Leigh Through Mount Hold Down

Leigh Bench Clamps provide exceptional holding power. These clamps were designed to be used in the 3/4inch bench dog holes found in most workbenches. The long 3/8inch threaded rod and speed nut allow the clamp to be used in benches up to 4-1/4inch thick. Alternatively; the unique design of the included threaded brass nut allows the Bench Clamp to be used in any size hole from 7/16inch to 1-1/8inch and on any flat surface. You can even mount them vertically! No holes; no problem! Simply drill 7/16inch or larger holes through your bench or work surface at the desired location; remove the small brass nut; add the supplied fender washers and tighten the speed nut. If you need a second clamp; just use/drill another bench hole or use a Surface Hold-Down Clamp and Clamp Anchor. The Bench Clamp also attaches easily to most drill press tables providing safe and secure clamping. Once again; just remove the brass nut and add the fender washers top and bottom. If your bench does not have holes and you don't want to dril